Adjustments; Angle - HOLZMANN MASCHINEN KAP 305ECO Mode D'emploi

14.2 Adjustments

14.2.1 Angle

Press the saw unit (7) into the lowered position
and press the release knob (6) to lock the
sawing arm in its transport position.
Release the mitre angle lock.
Turn the table (20) until the miter angle indicator
points to 0°.
Tighten the mitre angle lock.
Release the vertical angle lock (1) and set the saw unit to a
vertical angle of 0° (in other words the saw blade is at an
angle of 90° to the table. Tighten the vertical angle lock.
The edge of the angle bracket should run parallel to the saw blade.
If the saw blade is not parallel to the angle bracket, make the
adjustment as follows:
 Undo the lock nuts on the sawing head vertical angle using a
wrench or an adjustable wrench.
 Undo the lock nut which is secured by the 0° vertical angle setting
screw using a wrench or an adjustable wrench. Release the
vertical angle lock.
 Adjust the screw on the sawing head vertical angle with a
screwdriver by turning it clockwise and anti-clockwise so that the
saw blade is on the 90° angle bracket.
 Undo the screw which holds the pointer on the vertical angle scale
and set the pointer so that it points to 0°. Tighten the screw
again.
 Tighten the vertical angle lock and the lock nut to secure the
sawing head vertical angle
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
27
KAP 305ECO