Bevel Cuts; Compound Mitre Cuts - Metabo KGS 305 Instructions D'utilisation

ENGLISH
− Notch lever (56) of rotating table in
upper position.
Cutting the workpiece:
Loosen the locking screw (57) of the
1.
rotating table (55).
55 56
Push notch lever (56) down.
2.
3. Set to desired angle.
3
Note:
The rotating table engages in
positive stops at the 0°, 15°, 22.5°,
31.6°, 45°, and 60° position.
4. Tighten the rotating table's locking
screw.
5. Cut workpiece as detailed under
"Standard cross cuts".
Adjustable stop positions:
In addition to the positive stops any
desired stop position can be set:
Push notch lever (56) so far down
1.
that it will remain in the lower posi-
tion.
2. Turn rotating table until it engages.
Release locking lever (58).
3.
58
4. Rotate rotating table to the mitre
angle that is to be set as stop posi-
tion.
5. Tighten locking lever.
To use the positive stops again the
notch lever needs to be returned to its
upper position. When in lower position
the rotating table will only engage at the
adjustable stop position.
24
8.4

Bevel cuts

3
Note:
A bevel cut cuts the workpiece at
an angle other than 90° against its sur-
face. Depending on the angle of inclina-
tion it may be necessary to remove the
movable fence halves before cutting.
57
Maximum
(dimensions in mm):
22.5°
left
22.5°
right
45°
left
45°
right
47°
left
47°
right
Starting position:
− Sawhead fully raised.
− Movable fence halves pushed apart
and arrested in position.
− Cutting depth limiter engaged in
outer position.
− Rotating table in 0° position, the
locking screw of the rotating table is
tightened.
− Track arm not extended.
− Locking screw of the track arm loos-
ened.
Cutting the workpiece:
Loosen the ratchet lock lever (59)
1.
for sawhead tilt at the rear of the
saw.
Pull plunger pin (60) out.
2.
workpiece cross section
Width Height
approx. approx.
320 97
320 78
320 60
320 38
320 57
320 30
3. Tilt the motorhead slowly into the
desired position.
3
Note:
The track arm holder engages in
positive stops at the 0°, 22.5°, 33.9°, and
45° position.
4. Tighten the sawhead tilt locking
lever.
5. Cut workpiece as detailed under
"Standard cross cuts".
8.5

Compound mitre cuts

3
Note:
The compound mitre cut is a
combination of mitre and bevel cut. This
means the workpiece is cut at an angle
other than 90° against the rear guide
edge and against its surface. Depending
on the mitre angle and bevel tilt it may
be necessary to remove the movable
fence halves before cutting.
A Danger!
When cutting
mitres the saw blade is much more
exposed than normally - increased
risk of injury. Always keep sufficient
distance to the saw blade.
Maximum workpiece cross
(dimensions in mm):
Width with sawhead tilted approx.
22.5° 22.5°
left right
15° 309 309
22.5° 295 295
31.6° 272 272
45° 226 226
50° 205 205
60° 160 160
right
59
60
compound
section
47° 47°
left right
309 309
295 295
272 272
226 226
205 205
160 160