Installation; General - Hatco GRSR-15 Manuel D'installation Et D'utilisation

INSTALLATION

General

Hatco Round Heated Shelves are shipped with all components
pre-assembled. Care should be taken when unpacking the
shipping carton to avoid damage to the unit and the components
enclosed.
WARNING
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
ExPLOSION HAzARD: Do not store or use gasoline or
other flammable vapors or liquids in the vicinity of this or
any other appliance.
FIRE HAzARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
CAUTION
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
NOTICE
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit.
Do not drag or slide unit when moving or installing.
Carefully lift unit to prevent the rubber feet from tearing off.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
ImPORTaNT OWNER INFORmaTION section for
complete online warranty registration. See the
details.
2. Remove tape and protective packaging from all surfaces of
the unit.
NOTE: If drop-in unit, refer to SPECIFICaTION section for
countertop opening dimensions.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• For countertop units: make sure all the feet on the
bottom of the unit are positioned securely on the
countertop.
4. Continue to "Installing Drop-In Units" in this section if
installing a drop-in unit.
Installing Drop-In Units
Use the following procedure to install drop-in units.
1. Prepare the countertop opening. Refer to "Dimensions" in
the SPECIFICaTIONS section for countertop cutout
dimensions.
2. apply a bead of National (NSF)-approved sealant on the top
edge of the countertop cutout. The sealant must be rated
for use at a minimum temperature of 250°F (121°C).
3. Place the unit into the countertop opening.
4. Remove any excess sealant.
model GRSR-17
6
English
Form No. GRSRm-1112