Information; Displaying The Estimated Energy Consumption - REMEHA iSense Notice D'utilisation

heated. This switches off the built-in room sensor in the controller.
The temperature of the central heating water at that point is then maintained.
If it becomes too cold or too hot in the other rooms, you can increase or decrease the room
temperature there using push-turn button C on the controller. This increases or decreases the
central heating water temperature. You can fit thermostat valves to the radiators in order to
individually control the temperatures in these rooms.
The Fireplace mode should only be activated if the controller uses the room temperature to
i
control the temperature.
We advise that you close the radiator valves in the room in which the controller has been
i
positioned to prevent the room temperature there becoming too high.
The controller switches to weather-compensated control if the outside temperature sensor is
i
used.

6.4 Information

You can request operating information about your central heating system, such as the water
pressure in the central heating system and various temperatures, via Menu > Information. The
information available depends on your central heating unit.

6.5 Displaying the estimated energy consumption

In the information menu you can find the estimated energy consumption as calculated by the
controller. For the correct calculation set the parameters: Menu > Settings > Installer > kWh
calculation.
For more information see the installation and service manual.
EN
41