Installation; Location Of The Controller - REMEHA iSense Notice D'utilisation

Most important pictograms
Clock program active
Continuous day temperature
Continuous night temperature
Frost protection
Summer mode
Manual setting
Holiday program
DHW standby function switched off
Current room temperature
Room temperature set

3. Installation

3.1 Location of the controller

The controller is set to room control by default, which means that the inside temperature is used
to control the central heating. That is why it is best to locate the controller on an internal wall in the
room in which you spend the most time, such as the living room.
Do not locate the controller too close to heat sources (fireplace, radiator, lamp, candles, direct
sunlight etc.), or in places where it may be draughty.
Pictograms not shown
Controller requesting heat
Central heating boiler on for hot water
Central heating boiler on for central heating
Group 1 selected
Group 2 selected
Production of electricity
Warning symbols
Water pressure in central heating boiler too low
General warning symbol
Central heating boiler requires servicing
Battery in controller almost empty
No wireless connection
EN
28