Product contents and device overview
1
2
3
4
5
Start-up
ATTENTION!
1. Unpack all parts. Check the product contents for any damages from trans-
port. Should you identify any transport damage, do not use the device(!);
instead please promptly consult the customer service.
2. Undo the zipper of the pillow and remove the battery compartment.
3. Insert the batteries. You will need 4 x 1.5 V type AA batteries. Make sure the
polarity (+/-) is correct.
4. Put the battery compartment back into the foam and close the zipper of the
pillow.
5. Attach the pillow to a back rest using the cord strap.
6. Move the On/Off switch on the side of the pillow to the I position to turn it on.
7. Observe the maximum duration of use of 15 minutes.
8. Move the On/Off switch to the 0 position to turn it off.
When the device starts to lose power, you should replace the batteries.
11
1 Massage cushion
2 Cord strap for attachment to back
rests
3 On/Off switch
4 Zipper
5 Battery compartment (on the
back of the pillow, under the
cover)
Not shown:
•
4 x 1.5 V batteries, type AA
EN