Starting The Machine; Stand-By Function - LAVAZZA A MODO MIO Minu Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

No liability is held for damage caused by:
• incorrect use not in accordance with the intended
purposes;
• repairs not carried out by authorized service centres;
• tampering with the power supply cable;
• tampering with any parts of the machine;
• the use of non-original spare parts and accessories;
• failure to descale;
• storage at temperatures below 4°C;
• use in places with temperature below 10°C or above
40°C;
• use in places with relative humidity above 95%;
• use of capsules others than indicated.
In these cases, the warranty is not valid.

STARTING THE MACHINE

Place the coffee machine on a flat and stable surface, far from
water and heat sources. Disconnect power supply, if any. Machine
damages due to non-observance of these indications are not cov-
ered by warranty.
Strong electromagnetic interferences can influence the normal ma-
chine operation. If necessary, switch off the machine with the main
switch, and then switch it on again to reactivate the operation. If the
problem remains, use the machine in a place not subject to electro-
magnetic interferences.
Lift and remove the cover, then the
1
water tank itself.
Rinse off the tank.
2
Fill the water tank up to the MAX
3
level indicated, using only fresh
drinking water. Refit the tank.
Hot water and other liquids can
damage the tank and the machine.
Do not operate the machine with-
out water: make sure that there is
enough water in the tank.
MACHINE SETTING
Insert the power supply cable.
4
Press the start-up/stand-by button to start the machine.
5
The coffee machine starts the heating cycle. The power-on/stand-
6
by button will start blinking with green light.
The machine is ready when the start-up/stand-by button is on
7
with the green steady light.

STAND-BY FUNCTION

To ensure the energy conservation the machine automatically
passes to the stand-by mode after 9 minutes of not being used.
This mode is indicated by the switching off of the button. The ma-
chine can be manually put in the stand-by mode by pressing the
appropriate button.
The machine can be reactivated by pressing the button again.
Make sure that the start-up/stand-by button is on with the green
steady light and that the coffee dispensing knob is in the stop position
before manually putting the machine to the stand-by mode.
EN

Publicité

Table des Matières
loading

Table des Matières