Novoferm 45-1 Manuel De L'utilisateur page 7

Table des Matières

Les langues disponibles

Unique identification code of the product-type: Sectional Door Industrie 45-1

Type, batch or serial number or any other element allowing identification of the construction product as required pursuant to Article 11(4): see CE mark

Intended use or uses of the construction product, in accordance with the applicable harmonised technical specification, as foreseen by the manufacturer: manual or power

operated door, intended for installation in areas in the reach of persons, and for which the main intended uses are giving safe access for goods and vehicles

accompanied or driven by persons in industrial, commercial or residential premises.

Name, registered trade name or registered trade mark and contact address of the manufacturer as required pursuant to Article 11(5):

System or systems of assessment and verification of constancy of performance of the construction product as set out in Annex V: System 3

In case of the declaration of performance concerning a construction product covered by a harmonised standard:

The Notified Body, NB No.: 0044 TÜV Nord Cert GmbH, D-45141 Essen, SP Technical Research Institute of Sweden, SE-501 15 Boras, BDA Test Institute, NL-4200 AJ

Gorinchem conducted product testing based on type approval and issued: Test reports detailing the performance characteristics of the product. The company's in-

house production control complies with the requirements of EN ISO9001:2008.

Declared performance:

Key characteristics

Watertightness

Release of dangerous substances

Resistance to wind loads

Thermal resistance

Air permeability

Safe opening (doors that move vertically)

Definition of geometry of glas components

Mechanical resistance and stability

Operating forces (power operated doors)

Durability of watertightness, thermal resistance and air permeability against degradation

The performance of the product identified in points 1 and 2 is in conformity with the declared performance in point 9 and, when combined with the prescribed Novoshaft 5.15,

10.

5.24, 5.24 WS, 9.15, 9.20, 9.24, 9.24 WS, 6.65 DU, 14.15, GTA 4000, 803S, Run 601 door operators, complies with the pertinent provisions of

the EC Machinery Directive (Directive 2006/42/EC) / harmonized technical specification: EN 12453:2000

the EC Low Voltage Directive (Directive 2006/95/EC) / harmonized technical specification: EN 60335-1:2010, EN 60335-2-95:2004

the EMC Directive (Directive 2004/108/EC) / harmonized technical specification: EN 61000-6-2:2005, EN 61000-6-3:2007

This conformity has been confirmed by the Notified Body indicated in number 7.

This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4.

Signed for and on behalf of the manufacturer by:

Frank Wiedenmaier, Member of the Management Board / COO

Waardenburg, 07.03.2013

......................................................................................................................................................

We hereby confirm compliance with the manufacturer's specifications.

Place, Date:

This user manual must be given to the customer and must be kept within easy reach during the entire period of use.

DECLARATION OF PERFORMANCE No. 0001-CPR-2013

Novoferm Nederland BV

Industrieweg 9

4181 CA Waardenburg, Nederland

Tel.: +31(0)418 654700 / Fax: +31(0)88 8888505

E-mail:

info@novoferm.nl

Signature:

Name and address of installation firm