Electrical Connections; Prior To Startup - Beko FSE 1000 Notice D'utilisation

en

Electrical connections

Warning
This appliance must be grounded.
• Check whether the power type and voltage
in your region corresponds to the one stated
on the rating label inside the appliance.
• The electrical safety of the appliance is only
assured when the grounding system in the
house is installed in accordance with
regulations.
• When placing the appliance, do not let the
power cable get stuck under it; otherwise the
cable will be damaged.
• Ensure that the plug remains readily
accessible. Do not use a multiple adapter bar
or an extension cable.
• The electrical specifications of your appliance
is given on the rating label located inside the
appliance.
• Route power cable to allow easy connection
and disconnection after installation.
• A contact separator should be used if the
power cable is not accessible. (for built-in
models)
Get to know your appliance
Warning
Below information about accessories are
supplied only for reference. Below accessories
may not be exactly same as the accessories
of your appliance.
Fig. 1
1.
Reflectors
2. Top trim
3. Fast-Freeze switch
4. Indicator lights
5. Thermostat knob
6. Ice bank
7. Fast-freeze compartment
8. Frozen-food compartments
9. Adjustable front feet
Do not place hot objects or any
appliance that generates heat
on the top trim otherwise the
top trim may be damaged.

Prior to startup

Before you start operating your appliance, the
following points should be re-checked for
safety:
• Is the appliance standing level on the floor?
• Is there sufficient space for good air
circulation?
• Is the interior clean?
'Cleaning and care')
• Set the thermostat knob half way between
1 and 4 or Min. and Max.
• Now connect the appliance to the mains.
Do not place foodstuff into the refrigerator until
the temperature has reached the desired level.
3
en
(Also see the section