Door Conversion - Linea 2000 DOMO DO926BFK Mode D'emploi

e screwdriver / Flat bladed screwdriver / Hexagonal spanner
unplugged and empty.
· Don't overload the cabinet.
must be saved to do the reinstallation of the door.
· Caution: please keep the products away from the fire or similar glowing substance before
you dispose the refrigerator.
flat as this may damage the coolant system.
· Caution : Not for outer camping use (ex. Tent)
at 2 people handle the unit during assembly.
· Caution: For indoor use only.
· Caution: The appliance can not be used in public transportation.
e the door swing reversed, we recommend that you contact a
· Do not freeze food again after it has been defrosted already.
t bladed screwdriver / Hexagonal spanner
n. You should only try to reverse the door yourself if you believe
· Do not place carbonated liquids such as fizzy drinks into the freezer.
ed to do so.
· Be careful when consuming ice lollies straight from the freezer to avoid freeze burns.
lips style screwdriver / Flat bladed screwdriver / Hexagonal spanner
· Do not take anything out of the freezer with wet hands.
unit is unplugged and empty.
· The freezer produces sounds when the compressor pumps the refrigerant around. This is
do the reinstallation of the door.
moved must be saved to do the reinstallation of the door.
normal.
the unit flat as this may damage the coolant system.
· Make sure that all food in the freezer is covered.
amage the coolant system.
mend that 2 people handle the unit during assembly.
· Do not press together the food. The air should be able to circulate around the food.
e the unit during assembly.
t to have the door swing reversed, we recommend that you contact a
· Do not leave the door open for too long. Also make sure that the door is always properly
echnician. You should only try to reverse the door yourself if you believe
closed.
eversed, we recommend that you contact a
e qualified to do so.
· Label the food with the date to be able to check the expiration in the freezer.
try to reverse the door yourself if you believe

DOOR CONVERSION

ge cover.
1. Remove the cover plate of the screws. Remove the three screws and then the upper
hinge that holds the door in place. Lift the door off and place it on a soft surface to
prevent scratching.
inge. Lift the
on a padded
upper hinge. Lift the
m scratching.
place it on a padded
2. On the bottom of the door there is a door stop and a Teflon bush to guide the hinge.
nt it from scratching.
Move this to the other side.
screw and plastic
r block, screw and plastic
oor and move
upper door and move
osite side. You may
de. You may
the door block to fit the
r block to fit the
3. Remove the metal screws, hinge and cover plugs. Place them on the other side. Lift the
dle hinge by removing
he lower door and place
www.domo-elektro.be
urface to prevent it from
45
DO926BFK