Linea 2000 DOMO DO926BFK Mode D'emploi page 41

PARTS
1. Temperature control knob
2. Shelves
3. Cover for vegetable container
4. Vegetable container
5. Freezer drawers
6. Levelling feet
7. Door shelves
8. Door bottle shelf
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth
and the inside with a wet, lukewarm cloth. Avoid placing the cabinet in a narrow recess
or near any leave source, direct sunlight, or moisture. Let air circulate freely around the
cabinet. Keep the rear of the refrigerator 127mm away from the wall.
· Location
· Select a place with a strong, level floor.
· Allow 5 cm of space between the back of the refrigerator and any adjacent wall.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated
on the rating label of your appliance corresponds to the voltage in your home. A different
voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that
may occur as a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 3 hours before turning it on. This way the refrigerant
can settle.
· Allow the appliance to run empty for 24 hours so the compartment can cool to the
www.domo-elektro.be
1
2
3
4
5
6
7
8
41
DO926BFK