Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
e screwdriver / Flat bladed screwdriver / Hexagonal spanner
unplugged and empty.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
must be saved to do the reinstallation of the door.
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of
flat as this may damage the coolant system.
a leak caused by damage to the cooler elements, move your fridge from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.
at 2 people handle the unit during assembly.
CLEANING
e the door swing reversed, we recommend that you contact a
t bladed screwdriver / Hexagonal spanner
n. You should only try to reverse the door yourself if you believe
Do not use abrasive cleaning agents or solvents.
1.
Disconnect the mains plug from the mains socket.
ed to do so.
2.
Take out the food and store in a cool location.
lips style screwdriver / Flat bladed screwdriver / Hexagonal spanner
3.
If necessary, defrost the refrigerator/freezer. To speed up the process, a pan of hot water
do the reinstallation of the door.
can be placed in the freezer.
unit is unplugged and empty.
4.
Wipe the condensation off with a cloth or sponge.
moved must be saved to do the reinstallation of the door.
amage the coolant system.
5.
Clean the appliance with a soft cloth, warm water and detergent.
the unit flat as this may damage the coolant system.
e the unit during assembly.
6.
Wipe the door seal with clear water only and then wipe dry thoroughly.
mend that 2 people handle the unit during assembly.
7.
After cleaning reconnect and adjust the temperature control knob as desired.
t to have the door swing reversed, we recommend that you contact a
eversed, we recommend that you contact a
echnician. You should only try to reverse the door yourself if you believe
8.
Put the food back into the appliance.
try to reverse the door yourself if you believe
e qualified to do so.
DOOR CONVERSION
1.
Remove the cover plate of the screws. Remove the three screws and then the upper
ge cover.
hinge that holds the door in place. Lift the door off and place it on a soft surface to
prevent scratching.
inge. Lift the
on a padded
m scratching.
upper hinge. Lift the
2.
On the bottom of the door there is a door stop and a Teflon bush to guide the hinge.
place it on a padded
Move this to the other side.
screw and plastic
nt it from scratching.
oor and move
r block, screw and plastic
upper door and move
de. You may
osite side. You may
r block to fit the
the door block to fit the
42
dle hinge by removing
DO927BFK
he lower door and place
Publicité
Table des Matières
