+
It is impossible to describe all camera
types and their individual dedicated flash
functions within the scope of these instruc-
tions. Therefore, please refer to the flash
mode description in your camera's operating
instructions to find out which functions are
supported and which ones have to be set
manually on the camera!
Bij het gebruik van objectieven zonder CPU
(bijv. objectieven zonder autofocus) treden
ten dele beperkingen op!
k
134
3 Preparing the flash unit for use
3.1 Mounting the flash unit
Mounting the flash unit on the camera
+
Turn off the camera and flash before
mounting or removing.
• Turn the knurled nut
unit housing as far as it will go. The locking
pin in the adapter shoe is now fully
retracted into the case.
• Slide the flash unit foot completely into the
camera accessory shoe.
• Turn the knurled nut
housing as far as it will go, clamping the
flash unit in place. If the camera does not
have a locking hole, the spring-loaded
locking pin retracts into the adapter case
so as not to damage the surface.
Removing the flash unit from the camera
+
Turn off the camera and flash before
mounting or dismounting.
• Turn the knurled nut
unit housing as far as it will go.
• Remove the flash unit from the camera's
accessory shoe.
towards the flash
towards the camera
towards the flash