Miele PTD 701 Notice D'utilisation page 73

12 Error pictograms
Errors are displayed as pictograms. If many errors occur, washing will still be possible but the end wash re-
sult will be impaired. Please therefore rectify any error as soon as possible.
If you are unable to rectify the error yourself:
 Contact an authorised service technician.
Cause/meaning
Lack of rinse aid
Lack of detergent
Upper wash field is blocked
Lower wash field is blocked
For machines with an integrated softener:
Lack of salt
Machine with external partial demineralisation
cartridge:
Partial demineralisation cartridge used up
Machine with external full demineralisation car-
tridge:
Full demineralisation cartridge used up
Door was opened at an inadmissible time
(e.g. during washing)
Lack of water
Energy optimisation active
Service interval expired
Strainer clogged
Check the scaling
Various
INFO By tapping the pictogram, additional information will appear on the display.
Remedy
Fill the built-in storage tank or replace the con-
tainer. Prime the dosing device ( 6.3.2).
Remove the obstruction and restart the pro-
gramme.
Fill the salt container with regeneration salt
( 10.2).
Replace the partial demineralisation cartridge.
Reset the water back-flow counter (PIN
menu  7.12).
Have the resin of the full demineralisation car-
tridge replaced by an authorised service techni-
cian. Reset the water back-flow counter (PIN
menu  7.12).
Close the door and restart the programme.
Open the on-site water supply.
Have the water inlet filter cleaned by a service
technician or have a new water inlet filter in-
stalled.
Have the solenoid valve repaired by an author-
ised service technician.
Wait until the on-site energy optimisation
equipment switches off.
Contact an authorised service technician.
Remove, clean and replace the filter cylinder
and strainer.
Starting the descaling programme (PIN
menu  7.6).
Tap the pictogram and note the error code.
Contact an authorised service technician.
Error pictograms
71