Publicité
Les langues disponibles
Les langues disponibles
LGB logo. If the contact is installed
with the logo on the right side of the
track (in the direction of travel), it will
trigger the whistle as the model
passes.
Brake: To trigger the "squealing"
brake sound, reduce the model's
speed slowly. This requires a skilled
hand and a little practice.
Standing sounds: With the Multi-
Train System, you hear the fan in its
lowest setting while the railcar is
standing.
To hear the standing sounds with an-
alog operation, a low voltage (approx.
6.5 volts) must be maintained on the
tracks. Turn the throttle to a low set-
ting so that the railcar does not yet
start, but you can hear the sounds.
Hint: To obtain standing sounds with
analog operation while the throttle is
turned off and when reversing the
railcar's direction, the 65011 Sound
Unit Power Storage must be
installed. For questions regarding the
installation of the 65011, please con-
tact your authorized retailer.
Adding sound to 2x390 and 2x393:
To equip these models with sound,
we recommend the following prod-
ucts:
- 65004 European Electric Loco
Sound Unit
- 65011 Sound Unit Power Storage
On the main circuit board of the rail-
car, there are two pins between the
two motor plugs. These pins can be
used to connect the 65004 Sound
Unit. The 65011 is not needed when
operating with the LGB Multi-Train
System.
If there is not enough space inside
the railcar or if you prefer not to dis-
assemble the model, you can place
the Sound Unit in a freight or pas-
senger car and connect it to the rail-
car via the multi-purpose socket
(only 2x393).
20
Lighting
This model features directional light-
ing: Three white front lights and one
white rear light. Transparent red
stickers are included with the model
to obtain a prototypical red rear light
when running without a train.
The model has a "flat" multi-purpose
socket, with a removable cover, on
each end wall (only 2x392 and
2x393, Fig. 4). These sockets can be
used to provide track power to LGB
cars with lighting or sound electronics.
To remove the cover of a socket, pull
it straight out. If the cover is tight,
gently use a small straight screw-
driver to pry it out. (Do not pull out
the rectangular outer housing.)
Power Supply
Attention! For safety and reliability,
operate this model with LGB power
supplies (transformers, power packs
and controls) only. The use of non-
LGB power supplies will void your
warranty.
Use this model with LGB power sup-
plies with an output of more than 1
amp.
Catenary Power Operation
This railcar can be operated with a
powered catenary system (see Oper-
ating Modes). The bottom of this
model is marked with a red dot.
Place the model on the track with the
red dot pointing to the rail that is not
connected to the catenary power
supply (Fig. 5).
Hint: To operate multiple trains on
the same track, we recommend the
LGB Multi-Train System (see Multi-
Train System). With the Multi-Train
System, you can use an unpowered
catenary system for prototypical
appearance.
CAUTION! This model may be pow-
ered with a catenary on analog lay-
outs only. For operation with the dig-
ital Multi-Train System, the model
Publicité
