Zanussi ZWG 6125 Notice D'utilisation page 26

Water inlet
Warning!
This appliance must be connected to a cold
water supply.
Attention!
Before connecting up the appliance to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris that
may have collected.
Attention!
Do not use the hose from your previous
appliance to connect to water supply.
The other end of the inlet hose which connects
to the appliance can be turned as showed in
the picture.
Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
position of your water tap. Set the hose
correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the
ring nut again to prevent leaks.
26
1. Connect the hose to
a tap with a 3/4"
thread. Always use
the hose supplied
with the appliance.
Attention!
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine. In this
case, make sure the
end cannot come
unhooked when the