Wall Mounting; Safety; Recommended Screws; Mounting The Ohmpilot On The Wall - Fronius Ohmpilot Instructions De Service
Permet de régler en continu l'excédent de puissance de l'installation photovoltaïque dans une phase comprise entre 0 et 100 % (ou entre 0 et 3 kw) à l'aide d'une modulation en largeur d'impulsions
Masquer les pouces
Voir aussi pour Ohmpilot:
- Instructions de service (64 pages) ,
- Guide de démarrage rapide (8 pages) ,
- Installation et configuration (15 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wall mounting
Safety
Danger due to residual voltage from capacitors.
An electric shock can be fatal!
▶
Risk of burns from the heat sink when open.
This can result in personal injury.
▶
▶
▶
IMPORTANT! The IP 54 protection class only applies if the cover is firmly screwed to the
back.
Selecting wall
IMPORTANT! Different fixings may be required to fit the Ohmpilot depending on the type
plugs and screws
of surface. Fixings are therefore not included in the scope of supply of the Ohmpilot. The
installer is responsible for selecting the right type of fixing. The Ohmpilot must be moun-
ted with four screws. Ensure that the screws are tight and that the wall is stable.
Recommended
To install the Ohmpilot, the manufacturer recommends the use of steel screws with a dia-
screws
meter of 4 - 6 mm.
Risk of contamination or water on the terminals or electronics
This may result in damage to the Ohmpilot.
▶
Mounting the
1
Ohmpilot on the
wall
80
WARNING!
Wait for the capacitors to discharge. The discharge time is 15 seconds.
WARNING!
Allow heat sink to cool.
Do not touch the hot heat sink.
Wear suitable protective equipment.
CAUTION!
When drilling, ensure that terminals and electronics do not become dirty or wet.
2
Publicité
Chapitres
Table des Matières
