Staufenbiel DHC-2 BEAVER Instructions De Montage page 22

EN
Connect the two aileron servo plugs with the enclosed V-cable. Mount the landing flap linkage
onto the servo coupling. Program a channel on your transmitter for the servo flaps. When doing so,
pay attention to the rotational direction of the servo. Then tighten the screw on the servo coupling.
As shown in the illustration, mount the servo coupling and press it into the clips with slight pressure.
17
19
Mount the two wing braces with respectively one 2.4x8 mm screw and one 3x16mm screw as
shown in the illustration.
21
22
ASSEMBLY OF THE WING BRACES
18
20
22