Staufenbiel DHC-2 BEAVER Instructions De Montage page 20

EN
Set the tail wheel onto the bottom of the fuselage and screw connect it with two 2.5x8 screws.
Now check the neutral position of the yaw rudder. Thread in the two servo wires on the tail wheel
and into the couplings. Align the tail wheel and tighten the screws.
06
Mount the linkage of the pitch elevator onto the servo coupling, set the pitch elevator in neutral
position and tighten the screw on the servo coupling.
08
Take the two undercarriages and screw connect them as shown in the illustration, using two 3x16
mm screws for each.
10
20
ASSEMBLY OF THE TAIL WHEEL
ASSEMBLY OF THE LANDING GEAR
07
09
11