Staufenbiel DHC-2 BEAVER Instructions De Montage page 19

ASSEMBLY OF THE HORIZONTAL AND VERTICAL TAIL
Pull out the horizontal rudder linkage to the back a bit. Mount the linkage on the rudder horn of
the horizontal tail as shown in the illustration.
01
Set the vertical tail onto the horizontal tail as shown in the illustration and at the same time, mount
the servo linkages of the vertical tail onto the engaging piece underneath the horizontal tail. Then
push the tails into the fuselage.
02
Screw in the horizontal and vertical tail using the enclosed 3.22 mm screw as shown in the illust-
ration.
04
03
05
EN
19