Location And Connection - EUROM EK2K Still Manuel D'utilisation

could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
1. housing
2. grip
3. hot air discharge grille
4. control knob
5. thermostat knob
6. frame
Internal: PTC element and fan
The heater's direction of radiation can be adjusted from straight ahead to straight
up using the grip (90°).
The control knob of the EK2K Still & EK3K Still has 4 settings:
From top to bottom:
The thermostat knob is freely adjustable.

Location and connection

Remove all packaging material and keep out of reach of children. After

removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
Check if the control switch is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To

prevent the circuit overloading, check that no other appliances are connected to
the same group.
- O (off)
- ventilate only
- low power
- full power
33