Display And Control Elements - Starmix ISP Série Notice D'utilisation

Read the operating manual carefully before starting to use the vac-
uum cleaner. The operating manual provides important instructions
for safety, commissioning, operation, maintenance and care. Keep
the operating manual in a safe place and, in case you sell the unit,
hand it on to the next owner.
The manufacturer reserves the right to carry out modifications to
the design and equipment.
Do not perform any other work than described in this manual.
This machine is intended for commercial use, for example, in
hotels, schools, hospitals, factories, shops, offices and in the rental
business.
When unpacking, check for completeness and transport damage.
Before use, the operators should be provided with information,
instructions and training for the use of the vacuum cleaner and the
substances that it is to be used for, including the safe procedure for
the removal of the gathered material.
3

Display and control elements

Switch position Function
0 Vacuum cleaner is switched off.
A Vacuum cleaner is switched off.
AR Standby mode
IR Vacuum cleaner starts immediately
Automatic filter cleaning function
Fill level indicator*
Drehzahlregulierung*
Setting the suction hose diameter*
24 - en
Description
- Plug socket under voltage
- Plug socket under voltage
- Operation with power tool, filter cleaning function switched off
- When the tool is switched on, the vacuum cleaner automatically
switches on. After the power tool is switched off, the vacuum cleaner
runs on for approx. 10 seconds to prevent any residue from collecting
in the hose
- Plug socket under voltage
- Filter cleaning at start-up and automatic filter cleaning function after
differential pressure detection
- When the tool is switched on, the vacuum cleaner automatically
switches on. After the power tool is switched off, the vacuum cleaner
runs on for approx. 10 seconds to prevent any residue from collecting
in the hose
- Plug socket under voltage
- Automatic filter cleaning function starts after differential pressure
detection
- While the vacuum cleaner is running, the folded filter cartridges
are cleaned alternately when a certain negative pressure value is
reached, at which there is still sufficient air.
- The fill level indicator lights up when the tank is full and/or the suction
hose is blocked. On vacuum cleaners with dust class M and H, an
acoustic signal is also emitted
- Continuously adjust the suction power with the speed control
- On M/H/H-asbestos vacuum cleaners for volume flow monitoring,
when the minimum air speed drops below 20 m/s
* je nach Ausstattungsvariante