Multi-Changer Selection - Alpine CDA-7832R Mode D'emploi

Remote Control/Télécommande/
Controlador remoto
1
2
3
88
1
2 3
1
RUE-4180
SOURCE
A.S.U.
SOURCE
BAND
CHGR-X
BAND
CD Shuttle Operation

Multi-Changer Selection

Alpine's Ai-NET system will support up to 6 CD
Shuttles. When operating two or more
changers, the KCA-400C (Multi-Changer
Switching device) must be used. If you use 1
Switching device, you can connect up to 4 CD
Shuttles. If you use 2 Switching devices, you
can connect up to 6 CD Shuttles.
Press the SOURCE button on the CDA-7832R
to activate the CD Shuttle mode.
Alternatively, press the SOURCE button on the
Remote Controller (RUE-4180) to activate the
CD Shuttle mode. Proceed to Step 3 below to
select the desired CD Shuttle.
Press the BAND button on the CDA-7832R or
the RUE-4180 to activate the CD Shuttle
Selection mode.
The CD Shuttle Selection mode remains active
for 3 seconds after Step 2 is performed. Press
the BAND button until the desired CD Shuttle
indicator appears on the display.
Note: If the selected CD Shuttle is not con-
nected, the display will show "NO CHGR-
X."
English