Manual Storing Of Station Presets - Alpine CDA-7832R Mode D'emploi

1
RDS
M.I.X.
36
1
1 2
PTY P.PTY
4 5
RPT SCAN
Radio Operation
Manual Storing of Station
Presets
1. Select the radio band and tune in a desired
radio station you wish to store in the preset
memory.
2. Make sure that the Function indicator
illuminates, and press and hold any one of
the preset buttons (1 through 6) for at least 2
seconds until the station frequency on the
display blinks.
3. Press the preset button into which you wish
to store the station while the frequency
3
display is blinking (within 5 seconds).
The display stops blinking once the station
6 has been memorized. The display shows the
band, preset No. with a triangle (9) and
station frequency memorized.
4. Repeat the procedure to store up to 5 other
stations onto the same band.
To use this procedure for other bands, simply
select the band desired and repeat the
procedure.
A total of 30 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
FM 3, MW and LW.).
Note: If you store a station in a preset memory
which already has a station, the current
station will be cleared and replaced with
the new station.
English