Fermax VIDEO MARINE Manuel D'installation Et Utilisation page 31

Kit VIDEO MARINE
Kit VIDEO MARINE
EN
EVENTS AND SOLUTIONS TABLE
SYMPTOM
• It does not enter programming
mode.
• Auto-on does not work.
• It does not enter programming
mode.
• Auto-on works.
• There is no call, but there is panel
call monitoring.
• When the call button is pressed,
the Diagnostic LED does NOT
ligth at all.
• There is no call, but there is panel
monitoring.
• When the call button is pressed,
the Diagnostic LED emits short
fl ashes.
• The panel emits a continuous series
of short beeps.
• Very weak audio sound, or feedback
that cannot be eliminated with the
audio adjustment potentiometers.
• The door lock release/electric lock
is not working properly.
POWER SUPPLY (Leds)
O V O N
E R
L O
MA
DE
IN
SP A D
AI N
ON
50-
60 Hz.
50V F U
+ 1 A MA X. E N
8 V T E
1 . A LI
5 A K IT M E
N TA
D IG
C IO
IT A
N
L
ON
OV
ER
LO AD
Led ON
LED ON + OVERLOAD blinking indicates short circuit.
- Negative wire cross-section. Increase.
- Distance between panel and monitor. Increase cross-section
or add additional power supplies.
- Power supply position. Maximum distance to panel: 30 me-
tres/ 90 feet. Increase section or add additional power supply.
- Resistor 10 KOhms.
- Distance between panel and monitor. Increase cross-section
or add additional power supplies.
- Check that Jumper JP1 is set in the panel.
- Check that the monitor is switched on.
- Check cable «L».
- Monitor wrongly programmed. Program it again.
- Short circuit between «L» and «+».
- Short circuit between «L» and «-».
- Resistor 10 KOhms. There must be only 1 resistor, in the
furthest monitor.
- 12 Vdc door-opener with the 18 Vdc power supply:
* Make sure you are using a 12 Vdc (direct current)
door-opener, max. 0.3 A.
* Increase the cross-section of the negative.
* Distance between panel and monitor. Increase the cross-
section or add additional power supply..
- 12 Vac door-opener with the 12 Vac power supply:
* Make sure you are using a 12 Vac (alternating current)
door- opener, max. 0.8 A.
LED indicating maximum current limit exceeded. Reduce the load.
POINTS BE CHECKED
OVERLOAD
Pag 31