Switching The Background Illumination On And Off; Function Setting; Menu Diagram - Trotec MultiMeasure Professional TP9 Manuel D'utilisation

In order to deactivate the laser, press the "Enter" key
until the symbol "Target Laser On" disappears. The target
laser is no longer visible during the entire measuring
process.
The last laser target setting remains stored – even when
the power is off – until a new setting has been selected.
If the memory function is used during the
measuring process (see chapter 10.2.6), then the
target laser cannot be switched on or off via the "Enter"
key.
9.4 Switching the background
illumination ON and OFF
The measuring device is equipped with a backlit display for
measuring in darkness or locations where visibility is poor.
The background illumination can be switched on or off by
pressing the "Enter" key
is activated or deactivated.
The menu diagram in passive display mode (HOLD):
until the display illumination
Operating manual – English
The enter key can also be used to switch the
target laser on and off.
The last background illumination setting remains stored –
even when the power is off – until a new setting has been
selected.
If the memory function is used during the
measuring process (see chapter 10.2.6), then the
background illumination can no longer be switched on or
off via the "Enter" key.

10. Function setting

10.1 Menu diagram

The measuring device offers the user the opportunity to
carry out a variety of function settings before, after and dur-
ing the measurement process.
The following menu diagram shows the complete menu
cycle in passive display mode (HOLD).
B - 7 07