Installing The Refrigerator - Dometic Waeco CoolMatic CD50 Instructions De Montage Et De Service

Installing and connecting the refrigerator
7.1

Installing the refrigerator

A
NOTICE!
 Fasten the device as described in the operating manual to
prevent hazards.
 Keep objects clear of openings in the housing or mounting
structure (such as ventilation slots).
 The refrigerator is only suitable for installation in a fitted niche.
Once it is installed, only the front of the appliance may be
accessible.
 If brakes are applied fully, then strong forces act in the direc-
tion of travel. In order to prevent damage to the cooling appli-
ance and the vehicle interior, the cooling appliance should not
be installed with the front facing the direction of travel.
The appliance is designed for ambient temperatures between +16 °C and
+38 °C. In continuous operation, the air humidity may not exceed 90 %.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens, hot water pipes etc.
Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides). Therefore make sure there is adequate
ventilation (fig. 3, page 4).
No. in
fig. 3, page 4
1
2
3
4
The condensation which forms during normal operation of the refrigerator
can be drained off via two outlets on the appliance. For delivery purposes,
these outlets are sealed. The two outlets are located on the rear and on the
underside of the appliance (fig. 4, page 4).
➤ Choose the condensation outlet most suitable for the place of installation
and remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
36
Explanation
Cold intake air
Hot waste air
Condenser
Spacing above the fridge if insufficient air can circulate above
or at the side.
CD50, CRD50
EN