Installing And Connecting The Refrigerator - Dometic COOLMATIC HDC225 Instructions De Montage Et De Service

Installing and connecting the refrigerator

7 Installing and connecting the
refrigerator
Please note the following instructions for installation on boats:
D
DANGER!
If the device is powered by the mains, ensure that the power supply has
a residual current circuit breaker.
A
NOTICE!
The device can be tilted sideways up to 30°. When setting up the refrig-
erator, note that it must be fastened to take account of this. If you have
any questions regarding installation, consult your specialist dealer.
7.1 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather than the
right.
➤ Proceed as shown in the illustrations (fig. 2, page 4 to fig. 0, page 12).
7.2 Installing the refrigerator
Observe the following instructions when installing:
• Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the sides, fig. a, page 13).
Key for fig. a, page 13
No. Explanation
1 Cold intake air
2 Hot waste air
3 Spacing above the refrigerator if there is not sufficient air to circulate
above or at the side.
• Leave the device to stand for at least four hours before you connect it to the
power supply so that the oil can flow back into the compressor.
22
HDC195, HDC225
EN