Connection Cable - Zanussi ZES3921IBA Notice D'utilisation

Connection cable

• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F Tmax 90°C. Speak to your local
Service Centre.
Installation of more than one hob
min. 650 mm
If several 30 cm hobs are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and
supplementary seals is available at our
Authorised Service Centres. The relevant
installation instructions are supplied within the
kit package.
Assembly
R 5mm
+1
490 mm
min.
55mm
16
490 mm
270 mm
+1
270 mm
Place the sealing gasket A all around the edge
of the cut out.
Fit the hob in the cut out and push it down until
comes in contact with the kitchen top surface.
then remove the excess sealing.
A
min.
28 mm
www.zanussi.com