Voice Guide; Bluetooth Function - Trevi XF 1750KB Mode D'emploi Et Branchement

ENGLISH
MIC EQ
Turn the MIC EQ knob (13) to adjust the tones on the MIC1, MIC2 and wireless microphone.
Note: the EQ effect only acts on microphones.
DISCO-LIGHT EFFECTS
To activate the effects Disco Light press the LED button (4).
To cancel the effect Disco-Light, press the LED button (4).

VOICE GUIDE

To activate the voice guide (only in English), press and hold for a few seconds the PLAY button (6) on unit, the display will show
"ON" for 1 sec.
To turn off the voice guide, press and hold for a few seconds the PLAY button (6) on unit, the display will show "OFF" for 1 sec.

BLUETOOTH FUNCTION

1. Turn on the unit and press the MODE (3) button on unit, or the MODE (25) on remote control to select the Bluetooth function,
the display shows "BLUE".
2. In the Bluetooth mode, the symbol
3. Activate the Bluetooth feature on the external device to be coupled.
4. Initiate a search for devices. After select the "XF 1750KB".
5. Enter the password "0000" if required.
6. Press the PLAY button (6) on the unit or the key(26) on remote control, to start playing and the buttons NEXT (8) and
PREV (7), or the keys : NEXT (30) and 9 LAST (28) for the selection of songs.
PLAY ON INPUT USB/SD
1. Turn on the unit.
2. Insert a USB memory or an SD card into the corresponding inputs (10). Playback starts automatically.
3. To pause playback, press the PLAY button (6) on the unit or the key (22) on remote control, the display will show "PAUS".
4. To resume playback, press the PLAY button (6) on the unit or the key (22) of the remote control.
5. Press the NEXT (8) or key : NEXT (30) on remote control while listening to switch to the next track. Press the PREV (7) or 9
LAST (28) on remote to go to the previous tracks.
6. Using the numeric keypad (21) on remote control you can directly enter the number of the song you want to play.
7. Press once REPEAT button (20) on the remote, the display will show "ONE", to continually play the same track; press it a second
time, the display will show "ALL" to continuously play all songs in the USB/SD.
Note:
- The player may not support some USB/SD devices, this is due to the incompatibility of some processors.
- To avoid harmful interference, always connect USB devices directly to the unit, do not use extension cords.
- From the computer to format the USB memory/SD FAT (16 or 32).
AUX-IN
1. Connect any unit equipped with audio output, through a cable 3.5mm jack (not included) to the AUX IN (16);
2. Turn on the unit;
3. Press the MODE button (3) on the unit, or the MODE button (25) on the remote control and select the "LINE IN" function;
4. Use the external device from their commands.
USING THE WIRELESS MICROPHONE
1. Remove the cover at the back of the microphone, insert 2 "AA" size batteries paying attention to the polarity indicated and close
the cover;
2. Turn on the microphone by moving the center switch upward. If the power indicator blinks or does not light, check to see if the
batteries are charged and have been inserted with the correct polarity;
3. Adjust the volume by turning the MIC VOL knob (1);
4. If the power indicator flashes when the microphone is turned on, the batteries are low, replace them immediately.
on display will start flashing, the system automatically enters search mode.
13
XF 1750KB