Maintenance And Demolition - Rivacold FS Série Mode D'emploi Et D'entretien

use of the machine by staff that is unqualified, untrained, uninformed or not correctly equipped.
contact with electrically powered parts;
3.3.3.2. Necessary Individual Protection Devices
3.3.3.3. Signs Present
The machine is supplied with specific danger and forbidden signs; see Paragraph 3.4 – Safety Signs.
3.3.3.4. Attention warnings during machine use
During use of the machine, it is necessary to follow the attention warnings in this paragraph.
Only use the machine if all the safety protection devices are intact.
Do not remove, for any reason, the safety devices and protections installed.
Comply with all the safety and danger signs affixed to the machine.
Ensure all the safety and danger signs affixed to the machine are legible.
Wear all the IPD necessary, regularly checking their integrity (immediately signal any IDP that are no longer capable of
conducting the specific task they were assigned for).
Do not intervene on the machine without having fully and carefully read this handbook.
Use the auxiliary equipment and, however, any other machinery or equipment (electrical or pneumatic) only having understood
the instructions reported in the relative Use and Maintenance Handbook or after specific and formal training.
Immediately signal functioning anomaly situations.
Do not conduct any intervention (including cleaning) on movement units or hot surfaces.
Do not conduct unpermitted operations on the machine (refer to the instructions reported in this handbook).
Do not use the machine when under the influence or medicine or beverages that can slow your reflexes.

3.3.4. Maintenance and Demolition

3.3.4.1. Risks During Maintenance and Demolition Phases
During the maintenance and demolition phases, risks are present related to:
operations on the machine by staff that is unqualified, untrained, uninformed or not correctly equipped.
contact with powered electrical parts;
knocking or crushing by moved machine components;
contact with hot elements on the machine or relative equipment;
contact with the refrigerant.
3.3.4.2. Necessary Individual Protection Devices
3.3.4.3. Signs Present
The machine is supplied with specific danger and forbidden signs; see Paragraph 3.4 – Safety Signs.
3.3.4.4. Attention warnings during maintenance and demolition Phases
During the maintenance and demolition phases, it is necessary to follow the attention warnings in this paragraph.
Conduct the interventions requested using the standardised work tools (ladders, various tools) and always wearing the necessary
IPD.
The implementation of maintenance and demolition interventions must be performed by qualified, specifically trained staff.
Check that the power supplies are adequately sectioned and that nobody can reactivate them prior to concluding the requested
interventions (use of locks, adequate signs and consolidated work procedures); also check that any residual energy was
discharged before conducting the intervention.
Operate, as much as possible, on the machine and the tubing only after emptying it and before proceeding to restarting,
guaranteeing adequate cleaning of the system.
Obtain the necessary work permits and check all the preparation procedures of the machine for maintenance operations are
correctly conducted.
Use the auxiliary equipment and, however, any other machinery or equipment (electrical or pneumatic) only having understood
the instructions reported in the relative Use and Maintenance Handbook or after specific and formal training.
Do not use, for any reason, petrol, solvents or inflammable fluids to clean parts, but use commercial, approved detergent that is
inflammable and non-toxic.
Do not make changes, transformations or applications to the machine that could prejudice safety, without having obtained
written authorisation from the manufacturer.
Before restarting the machine, check that all the safety devices of the machine were restored.
UK
FS Pag. 42 Rev 00 02/12