Maintenance And Demolition - Rivacold ST Mode D'emploi Et D'entretien

UK
3.3.2.2 Necessary Individual Protection Devices
3.3.2.3 Signs Present
The machine is supplied with specific danger and forbidden signs; see Paragraph 3. 4 – Safety Signs.
3.3.2.4 Attention Warnings During Installation and Connection Phases
During the installation and connection phases, it is necessary to follow the attention warnings in this paragraph.
Follow the instructions relating to safety reported in Paragraph 3.3.1 – Lifting and Transport during the necessary movement
operations of the machine components.
Use the auxiliary equipment and, however, any other machinery or equipment (electrical or pneumatic) only having
understood the instructions reported in the relative Use and Maintenance Handbook or after specific and formal training.
Choose an installation location which:
includes sufficient space for normal use and maintenance of the machine,
enables the correct connections necessary for machine functioning,
In relation to electrical energy, the earthing system connection must be connected before any other connection to the
electrical mains line.
Protect connection tubing to energy sources using adequate rigid sheathing or cable passages.
Conduct the intervention requested using standardised work tools (ladders, various tools) and pay maximum attention to
elements that could cause tripping or cause cuts and trauma.
The operational settings of the machine cannot be dealt with until the machine is inspected: the presence of possible
assembly or installation errors could in fact lead to serious accidents for the operators responsible for the operations.
Before proceeding with the inspection and the first functioning of the machine, check its parts do not present any physical
damage due to knocks, tears or abrasion and that all the connections present were correctly conducted, with no possibility of
disconnection.
3.3.3 Machine use
3.3.3.1 Residual Risks during Machine Use Phase
During machine use the following risks are present due to:
use of the machine by staff that is unqualified, untrained, uninformed or not correctly equipped.
contact with electrically powered parts;
3.3.3.2 Necessary Individual Protection Devices
3.3.3.3 Signs Present
The machine is supplied with specific danger and forbidden signs; see Paragraph 3. 4 – Safety Signs.
3.3.3.4 Attention warnings during machine use
During use of the machine, it is necessary to follow the attention warnings in this paragraph.
Only use the machine if all the safety protection devices are intact.
Do not remove, for any reason, the safety devices and protections installed.
Comply with all the safety and danger signs affixed to the machine.
Ensure all the safety and danger signs affixed to the machine are legible.
Wear all the IPD necessary, regularly checking their integrity (immediately signal any IDP that are no longer capable of
conducting the specific task they were assigned for).
Do not intervene on the machine without having fully and carefully read this handbook.
Use the auxiliary equipment and, however, any other machinery or equipment (electrical or pneumatic) only having
understood the instructions reported in the relative Use and Maintenance Handbook or after specific and formal training.
Immediately signal functioning anomaly situations.
Do not conduct any intervention (including cleaning) on movement units or hot surfaces.
Do not conduct unpermitted operations on the machine (refer to the instructions reported in this handbook).
Do not use the machine when under the influence or medicine or beverages that can slow your reflexes.

3.3.4 Maintenance and Demolition

3.3.4.1 Risks During Maintenance and Demolition Phases
During the maintenance and demolition phases, risks are present related to:
operations on the machine by staff that is unqualified, untrained, uninformed or not correctly equipped.
contact with powered electrical parts;
knocking or crushing by moved machine components;
contact with hot elements on the machine or relative equipment;
contact with the refrigerant.
ST-SP Pag. 40 Rev 02 05/13