Safety Signs; Work Area And Position Of The Operator - Rivacold FS Série Mode D'emploi Et D'entretien

UK

3.4. Safety signs

Signaling labels are present on the machine, which are indicated in Table 4.
Table 4 – Description of the signaling labels present on the machine.
A
B
C
D
E
F
G

3.5. Work Area and Position of the Operator

The machine functions automatically requesting the intervention of the operator corresponding to the control and command software
only to manually start and stop and for functioning programming. The operator's work area therefore exclusively corresponds to the
control panel on the machine.
LABEL
This label indicates that it is forbidden to remove the safety devices and
protections installed on the machine; it is usually accompanied by the explicatory
writing:
This label indicates that it is forbidden to perform any intervention (including
lubrication and cleaning) in proximity of moving parts; it is usually accompanied
by the explicatory writing:
This label warns about the danger due to the presence of mobile parts in
proximity of the area in which the machine is positioned.
This label warns about the danger due to the presence of warm surfaces in
proximity of the area in which the machine is positioned.
This label warns about the danger due to the presence of elements under voltage
in proximity of the area in which the machine is positioned.
This label warks about the obligation to read the manual for the installation
Warning to the sharp parts durino condenser cleaning
DESCRIPTION
DO NOT REMOVE THE PROTECTION DEVICES
DON NOT REPAIR OR REGULATE DURING MOTION
.
.
FS Pag. 43 Rev 00 02/11