Maintenance; General; Daily Cleaning; Replacing Display Light Bulbs - Hatco Glo-Ray GRPWS Série Manuel D'installation Et D'utilisation

MAINTENANCE

General

Hatco Glo-Ray Pizza Warmers are designed for maximum
®
durability and performance with minimum maintenance.
WARNING
ELECTRIC ShOCK hAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Use only Genuine hatco Replacement Parts when
service is required. Failure to use Genuine hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in hatco equipment.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at
800-558-0607 or 414-671-6350.

Daily Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove the box stop w/sign holder on each shelf by
unscrewing the thumbscrews at each end of the box stop.
3. Wipe down all exterior and interior surfaces using a damp,
non-abrasive cloth. a non-abrasive cleaner may be used
for difficult stains. Hard to reach areas should be cleaned
using a small brush and mild soap.
4. Clean the side glass panels using a standard glass cleaner.
The glass panels can be removed for cleaning by reversing
the installation procedure shown in the INSTaLLaTION
section of this manual.
5. Wipe down each box stop w/sign holder using a damp,
non-abrasive cloth, then reinstall.

Replacing Display Light Bulbs

Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
The display lights are incandescent light bulbs that illuminate
the warming area. Each bulb has a special coating to guard
against injury and food contamination in the event of breakage.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. unscrew the light bulb from the unit and replace it with a
new, specially-coated incandescent light bulb.
NOTE: Hatco shatter-resistant light bulbs meet NSF standards
for food holding and display areas. For 120, 120/208,
120/240, and 120/208–240 volt applications, use Hatco
P/N 02.30.043.00. For 220–230–240 volt applications,
use Hatco P/N 02.30.058.00.
12
English
NOTICE
WARNING
Form No. GRPWSm-0117