Installation; General - Hatco Glo-Ray GRPWS Série Manuel D'installation Et D'utilisation

INSTALLATION

General

Hatco Glo-Ray Pizza Warmers are shipped with most
®
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC ShOCK hAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE hAzARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
The National Sanitation Foundation (NSF) requires that
units over 36" (914 mm) in width or weighing more than
80 lbs. (36 kg) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, 4" (102 mm) legs are included to allow for proper
cleaning access below unit.
1. Remove the unit from the carton. Two people are required
for this step.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for details.
2. Remove tape and protective packaging from all surfaces of
unit.
NOTICE
Do not lay unit on the side with the control panel. Damage
to unit could occur.
3. Install the 1" (25 mm) metal foot studs with rubber feet or
4" (102 mm) adjustable legs. Two people are required for
this step.
a. Carefully lay the unit on its side.
b. Install the feet or legs.
To install the 1" (25 mm)
rubber feet:
• Thread a foot stud into
the hole at each corner
on the bottom of the unit.
Tighten securely.
• Slip a rubber foot over
each foot stud.
To install the 4" (102 mm) adjustable legs:
• Thread a leg into the
hole at each corner on
the bottom of the unit.
Hand-tighten the legs
until snug. Do not over-
tighten.
c. Return the unit to the upright
position.
NOTE: 4" (102 mm) legs
adjustable for leveling the unit. Use a 5/8" (16 mm) open-
end wrench to make leveling adjustments once the unit is
placed in final position.
Foot
Stud
Rubber
Foot
4" Leg
are
Adjustable Tip
4. Slide each side glass panel into the upper channel, then
gently lower the panel into the lower channel.
Lower Channel
Side Glass Panel Installation (GRPWS-XXXXD shown)
5. Install the box stop w/sign holder on each shelf. To install:
a. Position the box stop on the shelf
b. Secure the box stop at each end using the supplied
thumbscrews.
Thumbscrew
Box Stop
w/Sign Holder
Box Stop w/Sign Holder Installation (GRPWS-XXXXT shown)
NOTE: Unit must be transported in the upright position.
6. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• make sure all the feet/legs on the bottom of the unit are
positioned securely on the countertop.
10
English
Upper Channel
Side
Glass
Panel
Form No. GRPWSm-0117