Maintenance - Hatco HBG Série Manuel D'installation Et D'utilisation

MAINTENANCE

General
WARNING
ELECTRIC SHOCk HAZARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning, setup, or
maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
414-671-6350; fax 414-671-3976.
NOTICE
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces. Using other wipes,
pads, or cleaners may damage ceramic glass surface.
DO NOT turn on unit until it has been cleaned thoroughly.
Ceramic glass surface must be clear of debris to prevent
burn-on.
Daily Cleaning
Cleaning Burned-On Residue
Cleaning Sugary/Sticky Spills
Pitting or indentation in glass surface may occur from
sugary spills. If pitting or indentation occurs, glass surface
must be replaced. To prevent further damage and possible
injury from broken glass, stop using unit immediately and
contact an Authorized Hatco Service Agent.
Cleaning Metal Marks and Scratches
NOTE: Check the bottom of all pans for roughness that could
scratch the glass surface.
NOTE: Damage caused by sugary/sticky spills or rough pan
bottoms is not covered under warranty.
CAUTION