Controls - Atag WU90 PMM Série Notice D'utilisation

USE

Controls

Main switch / display
The main switch allows you to swich off the fan and/or the lighting
without the remote control.
The display shows the selected fan setting. During automatic contnued
operation the selected setting will flash on the display.
Switching lighting on and off
Press the lighting button.
The lighting comes on.
Press the button again and the lighting goes out.
Dimming the lighting
To dim the lighting, press and hold the light switch until the dimmer
function is activated.
The lighting will switch on in the brightest setting and will become
dimmer the longer you depress the switch.
If you have used the dimmer function and then switch off the lighting,
the last dimming setting will be used when the lighting is switched on
again.
Switching on the fan
Press button +.
The extractor hood comes on at setting 1. The display on the extractor
hood will indicate the selected setting.
Adjusting the extractor capacity
Press button + of - to select a higher or lower setting. The maximum
setting you can select is setting 4.
EN 5