Hach MSM 1.5 Manuel D'utilisation De Base page 17

Figure 6 Controller details page
Add a sensor
Make sure that the controller is provisioned and connected to the HACH Server.
1. Make sure the controller is Online on the device list.
2. Connect the sensor to the controller physically.
Wait 30 seconds, then refresh the browser. The sensor is Online on the device list and the
device details page. Refer to
3. Make sure that the correct serial number, image and the correct measurement parameters of the
device are shown.
After 30 seconds, the measurement values are updated for all devices. Refer to
and navigation—Mobile device/PC
Configure a mA output card
Make sure that the controller is provisioned and connected to the HACH Server.
1. Select the mA output card from the controller details page.
2. Push MENU to access the mA output card settings. The mA output card will be locked. Refer to
Control function for devices
3. Push System setup to show a list of channels.
4. Select a channel and push Source.
5. Select a sensor from the list. Push OK to confirm.
6. Select a parameter from the list. Push OK to confirm.
Configure a profibus card
Make sure that the controller is provisioned and connected to the HACH Server.
User interface and navigation—Mobile device/PC
on page 13.
on page 15.
on page 13.
User interface
English 17