Tennant V-LWU-13B Manuel D'utilisation page 11

5. To install a new bag, slide the bottom of the green
bag collar into the bag holder until it "snaps" into place.
6. Push the top of the bag collar upward until the collar
"snaps" into place on the vacuum.
7. Tuck the bag corners into the bag compartment,
then zip the bag compartment closed.
VACUUM BELT REPLACEMENT
WARNING!
To Reduce the Risk of Electrical Shock
or Injury from Moving Parts, Turn the Vacuum Off and
Remove the Battery Before Servicing or Cleaning the
Vacuum.
Note:
To ensure maximum cleaning efficiency, the
belt should be checked regularly to be sure it is in good
condition. Check to see if the belt is stretched, cracked,
or if excessive slipping is occurring. Replace if needed.
1. Turn the vacuum off and unplug the charger from the
Charge Point.
2. Remove the battery.
Tennant V-LWU-13B (03-2019)
3. Turn the two screws a quarter turn to release the
bottom plate. Remove the bottom plate.
4. Remove the brushroll and the worn or broken belt
from the brushroll pulley and the motor drive shaft.
5. Loop the new belt around the motor drive shaft and
the brushroll.
English
EN
11