gala gar GALA 160 PFC Manuel Technique D'instructions page 13

2.3. ELECTRICAL INSTALLATION TO GENERATING SET.
The GALA 160 PFC appliances are suitable for electrical installation to generating set. These equipments include an
assessment system, which continuously verifies the supply voltage, so that the equipment incorporates a
compensation system of the input voltage, being operative in a range from 95 V to 265 V.
For correct operation with electrical generating set the following minimum powers are required:
Welding with 2.5 mm coated electrode (I2=80 A): Single-phase set, Pmin = 2.2 KVA
Welding with 3.25 mm coated electrode (I2=110 ÷140A): Single-phase set, Pmin = 3.3 KVA
Welding with 4 mm coated electrode (I2=130 ÷160A): Single-phase set, Pmin = 5.5 KVA
3. START-UP. OPERATION AND ADJUSTMENT CONTROLS.
3.1. OPERATION CONTROLS.
The equipment can be started up once the electrical supply installation has been carried out. This section describes
the control and regulation system of the GALA 160 PFC equipment.
Mark Description of use.
Selector of MMA/TIG process.
1
Indicator Display
2
Control potentiometer of the welding current value.
3 Fine selection by turning without pressing (Steps of 1 A)
Coarse selection by turning the potentiometer at once it is pressed.
GALA 160 PFC
GALA 160 PFC Control panel.
13