Setting The Videophone; Monitor; Adjusting The Screen; Changing The Monitor Bell-Tone - SOMFY V300 Notice D'installation

V300

7.1 Monitor

12
Bell volume dial
13 Speaker volume dial

7.1.1 Adjusting the screen

[1]. Press the "Menu" button (15).
[2]. Press briefly on the "Menu" button to navigate through the settings menu: the setting selected is
10
highlighted in orange.
[3]. Press the settings buttons (16) to change the value of the parameter selected (brightness, contrast, menu
language, time or date) until the desired setting is obtained.
[4]. Press the "Back" button (17) to exit the menu.
5

7.1.2 Changing the monitor bell-tone

16 bell-tones are available on the monitor.
To change the monitor bell-tone, keep the "BACK" button (17) depressed (approx. 5 seconds). The default or previous bell-tone is
played. You can then listen to the other bell-tones using the "settings buttons". Once you have made your choice, press the "Back"
button briefly to save the new bell-tone.

8.1 Responding to a visitor

When a visitor presses the call button on the door station, the monitor plays the bell-tone selected an image of the visitor is displayed.
Press the microphone and speaker activation button
You can communicate with your visitor.
Note: The V300 offers the possibility of taking a screen shot during a conversation with a visitor by pressing the
monitor briefly during the conversation.
then archived in the photo menu; see the instructions for the V300 kit, section "8.5 Viewing / deleting the photos".
Note: You can communicate with your visitor for a maximum of 2 minutes.
If you press the microphone and speaker activation button

8.2 Opening the gate

With the monitor screen switched on or off, press the button
If the monitor screen is on, it will switch off when the gate opens.

8.3 Unlocking the electric latch/lock

With the monitor screen switched on or off, press the unlock button
If the monitor screen was on, it switches off when the electric latch/lock is unlocked.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.

7 - SETTING THE VIDEOPHONE

This is used to adjust the volume of the monitor bell.
10
This is used to adjust the volume of the monitor.
225
1
6 7 8
9 11
.
A pictogram
appears at the top of the screen to indicate that the action is confirmed. The photo is
225
1
22
5 6 7
4
12
13
3
9
2
14

8 - USE

again, the monitor screen goes off and communication is cut off.
.
.
22
4
12
13
3
2
8
14
19
11
18
"Back" button (17)
EN EN
19
18
15
17
20 16
on your
9