Wireless Control Of A Somfy Rts Device Via The Monitor; Technical Data - SOMFY V300 Notice D'installation

V300

9.3 Wireless control of a Somfy RTS device via the monitor

[1]. Selected the channel associated with the device that you want to control by pressing the SELECT button (8): the indicator light of the
channel selected flashes (or the 4 indicator lights flash for channel 5).
Press the channel selection button as many times as necessary until the indicator lights show the required channel.
[2]. Control your equipment using the Open/On, STOP and Close/Off buttons on the monitor.
The equipment will react as stated in the table below:
Equipment
controlled
Garage door Open
Lighting On
Roller shutter Open
Gate Open
͉
͉
For more informations concerning the procedure, please refer to the installation guide of the V300 kit (section "7.1 Adding an RTS device")
Monitor
Power supply Type
Protection against inversion of polarity
Screen
Settings
Image memory
Mounting
Dimensions (w x h x d)
Operating temperature
Radio transmitter Frequency
Range
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
10
5
Open/on (5)
Stopped (if the door is moving)
-
• Stopped (if the roller shutter moving)
• Favourite position (if the roller shutter is stopped)
Stopped (if the gate is moving)

10 - TECHNICAL DATA

225
1
6 7 8
Press button:
STOP (6)
100-240 V / 50-60 Hz mains adaptor, 0.5 A
Output: 17 Vdc, 1.1 A
Yes
7'' (17 cm) screen - Resolution: 800 x 480 pixels
bell-tone volume, listening volume, brightness, contrast, colours,
language, time, date, bell-tone
100 photos on the internal memory
Wall mount
225 x 155 x 22 mm
From -10°C to +55°C
433.42 MHz
< 10 mW
200 metres (free field)
20
12
13
14
Close/off (7)
Closed
Off
Closed
Closed
EN EN
19
18
11