Replacing A Monitor; Operation; Responding To A Visitor; Opening The Gate - SOMFY V100 Notice D'installation

V100 video entry phone
Disconnect the power adapter from the monitor to be replaced.
[1]. Detach the monitor from its mounting bracket.
[2]. Remove the DC connector from the rear of the replacement monitor and connect the cable from the power adapter to this connector: black wire with
white lines on the left (+) and black wire on the right (-).
[3]. Connect the power adapter connector to the DC input at the rear of the replacement monitor in the direction indicated in the illustration (screws at the
bottom); the direction in which the power adapter wires are connected is important.
Important: It is essential to use the power adapter provided to power the replacement monitor.
Connect the door station to the connector P1 at the rear of the replacement monitor:
- terminal M+ on the door station to terminal M+ on the monitor
- terminal M - on the door station to terminal M - on the monitor
[4]. Clip the replacement monitor onto the mounting bracket.
Note: Position the power adapter wires between the mounting bracket and the monitor.
2
3
Monitor
Finish all of the cabling before connecting the monitor to
the mains.

5.1 Responding to a visitor

When a visitor presses the call button
Press the microphone activation button
from monitor 2, or both monitors to communicate with your visitor from both monitors.
Note: You can communicate with your visitor for a maximum of 2 minutes.
If you press the microphone activation button

5.2 Opening the gate

With the monitor screens on or off, press the button
If the monitor screens were on, they will switch off when the gate opens.

5.3 Unlocking the electric door-opener/lock

With the monitor screens on or off, press the unlocking button
If the monitor screens were on, they will switch off when the electric door-opener/lock is unlocked.
i
For more information on the V100 monitor, please refer to the instructions for your V100 video entry phone.
Copyright © 2015 Somfy SAS. All rights reserved.

4. REPLACING A MONITOR

Power adapter
wires
To the door
station

5. OPERATION

on the door station, the monitors ring twice and an image of the visitor is displayed on the 2 screens.
on monitor 1 to communicate with your visitor from monitor 1 or monitor 2 to communicate with your visitor
on one of the monitors again, the screen on this monitor only is switched off.
.
4
.
EN
4