Replacing A Monitor; Switching The Installation On - SOMFY V300 Notice D'installation

EN EN
Disconnect the mains power unit from the monitor being replaced.
[1]. Unhook the monitor being replaced from its mounting bracket by
sliding it upwards.
[2]. Mark the connectors so that they can be reconnected in the same
order on the new monitor:
[3]. Identify the position of the switch (18).
[4]. Disconnect the connectors of the monitor being replaced by pulling
them upwards slightly.
[5]. Remove the connectors supplied with the new monitor by pulling them slightly upwards and put them to one side in the event
they are required.
[6]. Position the switch (18) on the new monitor in the same position as that on the monitor being replaced.
[7]. Connect the mains adaptor connector at the rear of the monitor to the DC terminal as shown in the illustration.
Important: Do not connect the mains adaptor to a socket until all the wiring is completed.
[8]. The connect the second connector to terminal P2 and the third connector to terminal P1 (depending on the configuration of the
installation).
[9]. Clip the monitor onto its mounting bracket by first positioning the top
of the monitor on the station, then the bottom.
Note: Position the mains power adapter wires between the mounting
bracket and the monitor.

6.1 Switching the installation on

Once installation is complete, reconnect the gate motorisation to the power supply.
Next connect the monitor mains adaptor to an electrical socket.
8

6 - REPLACING A MONITOR

18
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
V300