Automatic / Manual Modes; Tilt Alert Mode - Futech Nexus Manuel Utilisateur

FUTECH-Nexus4langues_Doc_A 510 S 29/06/11 18:31 Page79
Mode
Automatic mode -
rotating
Automatic mode -
scanning
Laydown mode -
rotating
Laydown mode -
scanning
Manual mode -
rotating
Manual mode -
scanning

Automatic / Manual modes

The FUTECH NEXUS is in automatic, self-leveling mode when turned on.
Once the instrument has self-leveled, the laser head will start rotating with
600 rpm.
In manual mode, the laser does not self-level; this means that the beam will
rotate even if the laser is not leveled. It can therefore be used on inclined
planes such as stairs, roofs, or when manual grade setting is required. See
later section on setting slope in manual modes.

TILT Alert mode

The TILT feature stops the laser automatically if the laser is disturbed, pre-
venting inaccurate readings. It functions only when activated.
•
To activate this safeguard feature, keep pressed the TILT key {B-7} after
turning on the laser. The TILT LED {B-10} will blink rapidly while the laser is
initializing the TILT mode.
UP / DOWN
Laser buttons and
RIGHT / LEFT
remote buttons
Switches to point
mode
Moves scan
CW/CCW
Slope
Moves scan CW/CCW
Slope
Moves scan CW/CCW
UP / DOWN
remote buttons
Cycle through the
rotating speed
Cycle through the
scanning width
Cycle through the
rotating speed
Cycle through the
scanning width
Cycle through the
rotating speed
Cycle through the
scanning width
EN
79