Rotation Mode; Scanning Mode; Wall Mount - Futech Nexus Manuel Utilisateur

FUTECH-Nexus4langues_Doc_A 510 S 29/06/11 18:31 Page80
•
Thirty seconds later, the LED will blink slowly, indicating the TILT Alert
function is activated.
•
If the laser is disturbed while in TILT Alert mode, the head will stop
rotating, the beam will turn off, all LEDs will blink red.
•
Press the ON/Off key to turn off the TILT Alert function. Press again the
ON/OFF key to have the unit going back to the default settings (600 rpm,
automatic mode).

Rotation mode

The head rotates at three speeds: 0, 300, 450, 600 rpm. The default setting
is 600 rpm. The laser beam is more visible at slower rotation speeds.
• To cycle through the rotation speeds press the key {B-5}. Press once to
get to point mode, twice to 300 rpm, three times to get to 450 rpm. One
more time to get back to 600 rpm.
• When in point mode, the point can be moved to the right or left using
the UP/DOWN keys {B-3 and B-4}. It is also possible to move the head
manually to position the beam point.
To start rotation again, press the key {B-5}.

Scanning mode

For interior applications, scanning mode allows you to see the beam
easier at a distance.
The default width has medium dimension. The laser beam is more visible
at small width.
• To scan press the key {B-6}.
• To cycle through the scan width, press the key {B-6}.
• The scanning beam can be moved to the right or left using the
UP/DOWN keys {B-3 and B-4}.

Wall Mount

For interior application, such as drywall installation, it is recommended to
use the wall mount.
Use the tripod thread to fix the mount to the laser.
80