English; Safety Instructions; The Operating Elements; Intended Use - Eschenbach varioLED+ Mode D'emploi

Gewährleistung
Wir gewähren im Rahmen der gesetzlichen
Bestimmungen die Funktion des in dieser Anleitung
beschriebenen Produktes in Hinsicht auf auftretende
Mängel, die auf Fabrikationsfehler oder Materialfehler
zurückzuführen sind. Bei Schäden durch unsachge-
mäße Behandlung, auch bei Beschädigung durch Fall
oder Stoß, besteht kein Gewährleistungsanspruch.
Gewährleistung nur durch Nachweis über Kaufbeleg!

English

You have purchased a quality product from the
Eschenbach company that was "Made in Germany"
using state-of-the-art manufacturing processes. We
congratulate you on your decision.
The lens of high-quality, unbreakable PXM
is protected with a cera-tec
sistance is an important aspect of the quality and useful
life of the lens.

Safety Instructions

X Danger of glare and injury!
Never look directly into the sun or other bright
light sources using optical devices!
X Do not look directly into the LED lamp!
X Danger of fire! Lenses in optical devices can
cause significant damage by focusing light to
generate heat if handled or stored improperly. Be
careful never to leave optical lenses lying in direct
sunlight!
X Protect your magnifying light from impacts, mois-
ture and excess heat. Never lay your magnifying
light on a radiator or in direct sunlight.
X The clamping screws r must be screwed in tight
during use of the magnifying light!
X The light source of this luminaire may only be
replaced by the manufacturer or a service techni-
cian appointed by him or a comparable qualified
person.
X This magnifier lamp is only suitable for indoor use.
X Never use the magnifying light near to containers
filled with water!
material
®
hard coating. Scratch-re-
®
X Risk of tripping! Make certain that the power cord
does not pose a danger. Do not wind the power
cord around the magnifying light.
X The product may only be used with the supplied
mains adapter and its adapters.
X Inform other persons, particularly children, of
these dangers.
X The screw s on the head joint may not be
unscrewed.

The Operating Elements

q Lens
w Protective lid
e Control panel with:
- On/Off button
- Dimmer switch
- Segment button
r Clamping screws
t Pivot arm
y Multi-range AC adapter with power cord
(110-240V~/50-60Hz)
u Hole for pivot arm
i Clamping cylinder
o Table clamp
a Lens holder
s Screw head joint and upper arm joint (hex size 4)

Intended use

This product is intended exclusively for the enlarged
display of details in the domestic and industrial sector.
Setting Up
1. Screw the table clamp o to a table surface with
the clamping cylinder i.
2. Plug the swivel stand t into the hole u in the ta-
ble clamp o. Plug the appropriate country adapter
into the mains adapter.
3. Plug the AC adapter y into a properly connected
power socket.
4. Open the lens cover w. The lens cover is only
snapped on and can be removed completely if
required.
5. Press the large button in the middle to switch on the
magnifier lamp. Press the left button to switch from
segment lighting to ring lighting. To select one of the
three intensity levels (100%, 60%, 40%), press the
right button.
- 7 -