External Antenna; Tilting Hand (Proportional Output) - Sistematica Classic Manuel De L'utilisateur

EXTERNAL ANTENNA

The External Antenna is used to improve reception capacity of the
CONTROLLER in cases where the latter must be mounted in positions not
ideal for the operation of applications based on radio transmissions. It is
connected to the CONTROLLER via an SMA screw connector. The material
needed for fixing is provided in the kit.
For a correct installation of the External Antenna:
1. Insert the antenna thread on the mounting surface.
2. Insert the insulating rubber on the antenna thread.
3. Insert the cable with the toothed part facing the rubber just inserted on
the antenna thread.
4. Insert the washer and close everything by tightening the nut.
5. Cover everything with the protection on the cable.
ANTENNA
88
CNTR32 ANTENNA INSTALLATION
The CNTR32 receiver is supplied with an external antenna (STUB) and relative
gasket. It must be mounted on the SMA connector on the back of the controller.
For a correct installation procedure:
1. Insert the gasket on the SMA connector thread on the back of the controller.
2. Screw the antenna onto the thread of the SMA connector as far as it will go.
The receivers CNTR20 and CNTR32 have the ability to control an output
proportionally. When the desired key is pressed, with the handheld in a
horizontal (starting) position, the proportional solenoid valve is activated at
the minimum value. To increase the speed of movement relative to the key
pressed, it is necessary to tilt the handheld either to the left or to the right
by turning the wrist while keeping the key pressed down on the handheld.
As the inclination increases, the speed of the movement increases.
ASSEMBLY
SURFACE
SLOWS DOWN
RUBBER
CABLE
WASHER
NUT
PROTECTION

TILTING HAND (PROPORTIONAL OUTPUT)

STARTING POSITION
ACCELERATES
SLOWS DOWN
ACCELERATES