Reconfiguration Of The Master Output - Sistematica Classic Manuel De L'utilisateur

CODING OF THE SYSTEM WITH EMERGENCY KEYBOARD
The controller equipped with an Emergency Keyboard allows you to pair the
system in a simple and practical way, without having to open the controller's
box. For a correct coding procedure it is necessary intervene as follows:
1. Remove power to the controller.
2. Press the ENABLE key on the Emergency Keyboard.
3. Power the controller by keeping the ENABLE key pressed for 3-4 sec.;
then release the button.
4. Simultaneously press any 3 buttons on the handheld within 15 seconds of
switching it on.
5. At this point the handheld is paired with the controller; to verify the
correct coding of the system please test the operativity of the system's
commands.
CNTR20 WITH EMERGENCY KEYBOARD

RECONFIGURATION OF THE MASTER OUTPUT

The reconfiguration of the MO is an operation made to modify its activation
together with other outputs (OUT 1, OUT 2, OUT 3, etc.), with respect to the
standard setting. To change it:
1. Remove power to the controller.
2. Open by removing the two screws next to the connector (CNTR8 and
CNTR20) or the four screws on the bottom of the box (CNTR32).
3. Power the controller.
4. Simultaneously press the blue coding button on the receiver board and
the START button on the handheld for 3-4 sec., then release both.
5. Activate in succession, via the handheld, the outputs to which you want to
associate the MO.
6. Simultaneously press the blue coding button on the receiver board (fig.
p.86) and the STOP button on the remote control for 3-4 sec., then release
both.
7. At this point the new combination of MO with the selected outputs is saved;
to verify the correct reconfiguration test the system.
8. Close the receiver by tightening the two screws (CNTR8 and CNTR20) or
the four screws (CNTR32) removed in step 2.
The standard setting provides that, upon pressing each key on
the handheld, the corresponding output is activated together
with the MO.
87