Replacing The Fuse; Options; Emergency Keyboard - Sistematica Classic Manuel De L'utilisateur

POSITION OF CODING BUTTON & FUSE
CODING
BUTTON
FUSE

REPLACING THE FUSE

The system is automatically protected against current overloads and any
short circuits on the outputs. For further protection, a fuse is provided inside
the controller box. In case of replacement proceed as follows:
1. Remove power to the controller.
2. Open by removing the two screws (CNTR8 and CNTR20) or the four screws
(CNTR32) on the bottom.
86
3. Locate the damaged fuse on the electronic board.
4. Remove the fuse from its housing, then insert the new fuse in the space
provided (CNTR8 => 10A, CNTR20 and CNTR32 => 20A).
5. Power the controller and verify its operativity by pressing a key on the
handheld.
6. Close the box by tightening the two screws (CNTR8 and CNTR20) or the
four screws (CNTR32) removed in step 2.

OPTIONS

Sistematica controllers can be equipped with some options, such as an
Emergency Keyboard (CNTR8 and CNTR20), a Proportional Output (PWM on
CNTR20 and CNTR32 with Tilting Hand) and an External Antenna (standard
on CNTR32).
EMERGENCY KEYBOARD (CNTR8 - CNTR20)
The Emergency Keyboard allows the use of the system, as the name says,
in emergencies; for example in the event that the batteries of the handheld
are exhausted, or if the handheld is lost or for any reason it is not possible to
control the outputs from its handheld.
Through the Emergency Keyboard it is also possible to carry out the coding
procedure without having to open the controller.
FUNCTIONING
The outputs can be controlled via the Emergency Keyboard located on the
receiver. The Keyboard reproduces the numbering of the handheld exactly.
For correct use of the Keyboard, proceed as follows:
1. Power the controller.
2. Wait 3-4 seconds.
3. To execute a command, press the ENABLE key and at the same time the
desired numeric key on the emergency Keyboard.
It is not possible to control the outputs simultaneously from
the Emergency Keyboard and the handheld.